R/C Tech Forums - View Single Post - Serpent Project 4-X
Thread: Serpent Project 4-X
View Single Post
Old 06-09-2017 | 02:56 PM
  #270  
Byronf1's Avatar
Byronf1
Tech Adept
 
Joined: Dec 2013
Posts: 144
From: Guatemala
Default
Originally Posted by erchn
The pull rods for sure. I think the VTD will be better, but it's an awfully easy thing to switch back. I ran all of the parts at the latest CTS race in Fresno, CA, and the car was fantastic. I had a less than stellar outcome, but it wasn't the cars fault.

Honestly, the car just is much more predictable and consistent.
Thank you for the info!
for the 401738 it is a must to cut 401646 behind the 3rd most forward hole (just behind servo)
Byronf1 is offline  
Reply