Originally Posted by
disaster999
Have anyone tried to supply 7v to their PI/PM series servo that have a max input of 6.6v? I dont think theres an ESC out there with a BEC capable of delivering 6.6V. Its only 0.4V over the limit. Just want to use the maximum speed of this servo.
Most 1/10 servos deliver between 6v and 6.6v. Some high end speed control will give you adjustable options which can be up to 7.4v. Just set at 6.6v or below. Pushing it too high, might work for a little while, but you are run the risk of hurting the servo.