Hello!

I don't know if my question is regarding to this topic but still I am searching the answer to this problem:
- I have 2.4 GHz 2 channel radio transmitter and during the use I always open the antenna to full length (even during calibration the transmitter and ESC is recomended to do the setup at full antenna length)
- I always turn on first the transmitter switch and then turn on the ESC switch on my car
- I have set up the transmitter trimming function always in neutral position
- I have a filling that the steering servo is always slightly off the position, the position of servo is sometime different if I turn on and off the ESC and transmitter...why the position of servo motor is not always the same...what cause this difference in position of servo motor...any advice?

Thanks.