Originally Posted by
JoeW
17t 1900. But this is happening just going around a basic corner at partial throttle. I'm driving it like a grandma because it's basically new. I have the EPA at 80%. I'm not beating the hell out of it. It just doesn't like the loose and bumpy terrain.
I'll go into a corner and without warning the rear end will rotate completely around the front end like the front was stuck on something. Then going down the straight it will just start flailing side to side. It's so unpredictable.
Maybe slide the motor out and make sure the drive train is free everywhere. Did you make sure the diff action worked properly in each diff during the build? If the rear end is coming all the way around like that I fell like something has to be wrong somewhere. It seems like that is more than a set up problem. But I'm no pro.