R/C Tech Forums - View Single Post - Tekno MT410
Thread: Tekno MT410
View Single Post
Old 05-09-2017 | 03:00 PM
  #766  
0verkill's Avatar
0verkill
Tech Master
iTrader: (8)
 
Joined: Oct 2010
Posts: 1,189
From: Birmingham, AL
Default
Originally Posted by AudiJedi
0verkill, is your motor up against the center brace? Did you dremel anywhere to make enough clearance to get the proper mesh?

I'm definitely hearing conflicting information about 42mm motors and the 15T pinion. I'm about to start a build and would like to order a 16T pinion now if the 15T I have is going to require installing my motor up against the center brace.
It's right up against the brace, doesn't hurt anything, it's plastic. No dremel.
0verkill is offline  
Reply