R/C Tech Forums - View Single Post - sand in lipo hardcase
View Single Post
Old 05-06-2017 | 11:58 PM
  #3  
MaxxGabriel
Tech Adept
iTrader: (13)
 
Joined: Oct 2014
Posts: 247
Default

Originally Posted by Ominex
It really depends. I'd say that if it charged and is not puffed they more than likely it's fine. See if you can peel back the balance plug seal a little and shake out whatever is in there.

I had that happen to some cheap Turnigy batteries one time. One was just some small rocks but the other had some small bits of solder and flux left over from the factory...not good.
I ran it for a few minutes and had no problems, but I am going to try the plug seal thing in the morning.
MaxxGabriel is offline