Originally Posted by
Apco1
Anyone else have steering slop problems? Seems be from multiple places. A little in the hubs, some in the servo saver and tie rod ends either being to big or wearing to quickly.
Most seems to be in the servo saver. Like the steering posts are not big enough for the bearings in the servo saver. Any fixes?
Can't say I've seen slop in the steering bellcrank/bearing area but I do get slop via the steering bushing/bellcrank between the steering plate. I have some ideas I've yet to try.
Do you get slop in both the steering posts or just that one side? Check and replace the bearings - if the steering post had loosened at some point, those bearings could be shot. If it's not the bearings, swap the steering posts around to verify if one of steering post is dodgy or replace them both altogether.
For slop in the hubs, you could try the below:-
https://thequagraine.com/2016/08/23/get-rid-of-slop/
