Wanting to create a profile for my A800X my understanding is that the bulkheads are 0.5mm higher than the A800 and that it uses an AM06WL Hub which is 0.75mm higher than the A800 using AM06W. To account for that do I need to change the values for Y2 (+0.5 to 35mm) and LKing (+0.75 to 30.75mm)

When running the +0.5 width front balls for front arm sweep what do I need to change, my guess was X1 by 0.5mm?

Would appreciate your feedback, have a very dialled in A800 next to an A800X which I am about to throw at a wall! The changes to the car are probably great for carpet, high traction asphalt etc but for no traction, it sucks!