R/C Tech Forums - View Single Post - Tekin Rx8 Gen3 Thread
View Single Post
Old 03-23-2017 | 09:14 AM
  #49  
MX304
Tech Elite
iTrader: (21)
 
Joined: Dec 2011
Posts: 3,808
From: Texas
Default

Originally Posted by JRSlash
To be a little more specific, The single race I went last year that I saw the most dead esc's was PNB followed by AMS. I killed one during practice in which was replaced by the tekin rep (which I appreciate that) because it was new and under warranty and the second started acting up in the third heat and completely died the following event a week later. AMS I killed my last one and 2 of my friends killed theirs one went right up and bought a new one from an on-site vendor and the switch was defective. We just cut it off since the vendor sold out. They can tell you the exact number of esc that died in those events since you had to fill out a warranty card when you swap esc's on site.

Again, I am hoping that they really improved their quality because I was disappointed, specially for what I paid. And honestly, It was just the RX8, the RSX and the RS gen2 and RS Spec were great ESC's that never skip a beat the whole time I owned them. But for durability, power and value.... will be tough to beat the HW XR8 Plus and XR8 SCT Pro.
Hard landings are the number 1 way to kill the RX8. It doesn't surprise me one bit that PNB would be especially hard on them. The last one I had go up in flames was on a flat landing off a huge double that I hadn't figured out the timing on yet.
MX304 is offline