Originally Posted by
Norse
Those knuckles are the same as the SC6. The RB6 front steel axles look much like the other aftermarket front axles with the super thin hex. I would use metal spacers over the plastic should be 5mm by 7mm shims thus the thinner the better as you can tune in finer increments.
Thanks for your help. Sorry, few more questions.
What is the closest setup with the rb6 axle etc. compared to the standard axle setup? eg; 1mm inner, 2mm outer? I see the RB6 one pictured above comes with spacers/shims where as the Exotek doesn't.
Also, because the hex is so thin, should I consider spacers between hex and wheel?