Originally Posted by Djchow85

Picked up a flow works esc off someone else which they put the modified off road firmware

I'm wanting to use it in blinky 21.5t TC. Does the factory reset only reset the settings and not firmware as I tried it and I'm confused with the next point...

Mode 1 flashing red - auto brake?
Mode 2 medium flashing orange light - 10 options
Mode 3 fast flashing orange light - 10 options
Mode 4 flashing blue light - torque timing?

After this, the flashing lights follow the original instructions.

Which mode is to set initial drive? I assume this is punch?

Is brake set at a default strong level and I should turn down on the end point on my radio?

Should I just update the firmware to the v5.4 stock firmware? Unfortunately I don't have the bridge yet

Ok - I googled again and someone mentioned modes two and three are brake mode and initial brake. Mode 4 is initial drive? Will test this tomorrow and then see by the amount of available flashes

Feels like breaking some code in a modern indiana Jones movie...