New to me Tekin rs gen 2
Purchased a used buggy with a Tekin RS Gen 2 in it. I hooked everything up and did the factory reset holding down both buttons on the esc and then began setting up the esc. The esc calibrates properly with my remote and runs. The esc will not hold my setting as is flashing 3,4,5, and then 1 repeatedly. Reading the instructions this appears to be "big event lockout mode". The directions say this can only be removed via Hotwire link. Is this the case that a factory reset will not reset this esc when it is in the mode and I need Hotwire to unlock it?