Originally Posted by
Jorge T
I run the airtronics 94761z which has similar dimensions to the srg.
With the unimount I used 2x2mm bulkhead shims to lower the servo 4mm, almost touching the chassis.
Then use 2.5mm on the steering knuckles to take away bump steer. I also use a tall neck ball stud. If using a normal ballstud you may need 1mm more.
Thanks Jorge, tried doing that but the servo didn't feel solid to me which prompted my question. In looking back through the thread I saw where Landau had removed the unimount and used short standoffs, thinking of trying this method.