R/C Tech Forums - View Single Post - Tekno MT410
Thread: Tekno MT410
View Single Post
Old 01-25-2017 | 01:15 PM
  #430  
ezlight
Tech Master
 
Joined: Oct 2014
Posts: 1,167
From: Maine
Default
Originally Posted by Dr_T
You really run a 17T pinion on a 2200kv motor with the Badlands MX38s (the 176 mm diameter ones, not the 149mm 3.8s)? And it really wheelies less, than with smaller pinions? I would of expect the opposite, ...and fried electronics with that set-up.

17t tames the power down. I run a 17t on a 2100kv in my ET with no problems. MT is very similar.
ezlight is offline  
Reply