R/C Tech Forums - View Single Post - YOKOMO Touring Car BD-7
Thread: YOKOMO Touring Car BD-7
View Single Post
Old 01-22-2017, 10:02 AM
  #7405  
b20btec
Tech Master
iTrader: (11)
 
b20btec's Avatar
 
Join Date: Oct 2011
Location: Sugar Land
Posts: 1,188
Trader Rating: 11 (100%+)
Default
Originally Posted by ponchota
Just wanted to give an update with motor. I decided to keep the motor because shipping was too expensive. I ended up marking where the motor hits the upper deck and filed the corner of the motor to fit. It fits great now. I just need to get some new spur gears because my 39T pinion is the only one that meshes/seats well on the 96T spur. Got it powered up last night and I have some tweaking to do before she hits the streets of NH!

Thanks for all the help and support!
If you're bashing set it up for low traction to make the car easier to drive. I would run as much droop and ride height I could get away with.

I use a 14 to practice in a parking lot with a 4.5T motor. Running close to 6mm ride height 5.5 front, 4.5 rear droop. 388cst and yokomo black springs all around. Diff oil at 1k and roll centers set low.
b20btec is offline  
Reply