Originally Posted by
Slapjack
I have the racers edge horn on my '16 and just ordered another for my xb2. They are the exact size as the X-ray plastic ones and the holes lines up perfect.
Leads me to a question I have about the steering setup. I ordered the exotek steering rack arm for my xb2 but I got the xray 4 hole alum one for my xb4... anyone run that?i just noticed that on the stock one there is a small section that is thicker at the end where the steering turnbuckle connects but the X-ray alum version is just a flat piece all the way across. Will I need to use some shim to get the turnbuckle at the same angle as stock or doesn't the angle of that matter? I shoulda got the exotek cause it is an exact replica of the plastic stock arm.
You will need to run 5mm of shim under the 4 hole xray steering rack.
You will also need to get the 10mm ball studs. It is a very good upgrade.