Result of the test is the car is still great, good handling
!
However setting required 7mm shims to reach KIT high level.
Overall i ended up on P3 today but it was driven i had almost broken C-hub which i realised late and P1 was very strong but this time i had the best laptime
Originally Posted by
Marcika
Hi guys,
Quick question for this:
http://www.thercracer.com/2016/11/thercracer-tamiya-trf419x-floating.html?m=0
I am just about to test it
and found 4mm spacer each raise the steering horn up by 3mm as a result link hitting a bit top deck.
Servo Arm length from chassis is 13mm as kit setup. I achieved the same with 7mm spacers and 15mm screw.
Did i do something wrong when followed intsruction or this amount of shims has to be used?
Thanks
Marton