R/C Tech Forums - View Single Post - BEC voltage VS Servo voltage
Thread: BEC voltage VS Servo voltage
View Single Post
Old 12-28-2016 | 10:01 AM
  #3  
EbbTide's Avatar
EbbTide
Tech Elite
iTrader: (39)
 
Joined: Nov 2012
Posts: 4,264
From: Bay Area, Ca
Default
Originally Posted by Billy T.
Ohm's law states that the electrical current (I) flowing in an circuit is proportional to the voltage (V) and inversely proportional to the resistance (R). Therefore, if the voltage is increased, the current will increase provided the resistance of the circuit does not change.
So if I understand correctly, unless there is a resistor between the servo and the ESC, then the servo will be overloaded with a 7.4v bec?
EbbTide is offline  
Reply