Maybe I missed the post, but my kit didn't come with the special threaded droop screws. The build manual also shows normal screws that thread in from the top of the arms. I'll probably pick a set of those screws up when it's convenient.

Speaking of my kit, are you supposed to cut down the servo saver spring? Also, At max ride height, the screw for the steering links on the knuckles hit the a-arms. I don't think I plan on setting the ride height to max, but this still means you can't turn when it's jumping. Furthermore, I think I need to cut down the front screws that go into the front chassis brace into the plastic bulkheads. I checked the manual, and they're supposed to be the same length as the rear, but the rear has a plastic bumper acting as a spacer. The fronts dont have that bumper acting as a spacer. I mentioned too that my motor mount was a bit out of tolerance, but I sanded it. I didn't expect absolutely no issues. It does seem a bit odd though because 90% of the kit is near perfect fit and finish, but then there's little quirks that I, or others have had.