R/C Tech Forums - View Single Post - Piston with a machined hole in the side?
View Single Post
Old 12-13-2016 | 08:50 AM
  #8  
NitroVein
Tech Fanatic
 
Joined: Dec 2010
Posts: 805
Default

I would have to disagree, and I believe tests has been done on larger 2-strokes. Getting circulation on the gases bellow the piston crown will cool it, it would be very strange if it didn't. Even a problem on 4-strokes if you don't have enough.

But the reason this engine has a boost port like that is cost. (That's not a bypass port)
NitroVein is offline