Here is a picture of my outdoor car. I used a Yokomo YRX12 chassis as it had the widest spacing to move the weight of the batteries away from the center line of the car for better weight transfer to the outside wheels to increase grip in corners. The upper and lower motor pod plates are CRC along with the dampener tubes. It also has the IRS front adjustable role center caster blocks, Niftech rear axle and right side hub with an IRS left side clamping hub. I used Castle Creations 16ga wire with the wire soldered to the lower tabs on the motor. OD cleaned up the electronics wire as he is real good at soldering to printed circuit boards on the servo and ESC. I have already ruined two LRP's trying to shorten the leads. Thanks for the pictures, OD.