Jap TC3 - All rules and regs clearly posted.Pls read again carefully :
Rule No:
1.15 Only the following air holes and sizes are permitted in the bodyshells:
One (1) cooling hole may be cut in the front windscreen only (not intruding on either the roof or bonnet) with a maximum dimension in any direction of 60.00mm.
15.00mm maximum diameter hole in the roof for glow plug access.
Both front side windows and the REAR WINDOW can be removed for ventilation, except for the SIDE REAR WINDOWS, which must remain intact.
Re-fuelling hole maximum 50.00mm diameter.
Small holes can be made for the exhaust pipe, transponder and radio antenna.
No other holes are permitted.
1.19 General Dimensions MINIMUM (mm) MAXIMUM (mm)
Wheelbase 230.00 270.00
Width (without body) 170.00 200.00
Width (with body) 175.00 205.00
Length (including body and wing) 360.00 460.00
Height (to top of roof measured with a 10.00mm spacer under the chassis plate on levels) 120.00 175.00
Wing width inclusive 125.00 200.00
Wing chord - 50.00
Wing endplate 35.00mm x 50.00mm – equal size
Wing overhang (at rear) 10.00
Wheel diameter (excluding tire bead) 46.00 50.00+1mm tolerance
Wheel width (including bead) - 30.00+1mm tolerance
Tire width (across sidewalls) - 30.00
As for the weight including transponder,asked,corrected and answered already.Pls refer to the previous page.
Thank You.
