Originally Posted by
szymanski2oo1
thank you, have messaged them to see if they know if any will fit.
Couple of ways to go to seal off the chassis from water and such..
To get the best fit, must trim off the mounts for the nerf bars. Then measure width to start your search for the body size that fits tight. No matter what body you get it will require a custom fit. Will need some mods to get best seal. see what I did here.
http://www.rctech.net/forum/12848262-post133.html
Other option is to bolt on lexan to the mounts for the nerf bars. Then cut them to fit the body of your choice. This makes choosing a body easy, but requires trim work to get a tight fit. Check out this video about the 2:50 mark to see how the kit did this.
https://www.youtube.com/watch?v=gH1bAjyVToI
Make sure you figure out a way to get some air flow. My Pro8 had to have a good motor fan and vents to run mains without meltdown. Still got near 200F in summer, 165F in winter with fan.
3.0 would still make a killer SL Buggy.