I really hope someone can help here. I'm having an issue with my car set up, basically I can't get the motor to run.

I’m using it with a R2104 Futaba receiver, 5000Mah Haiyin 2S Battery Pack and RC4WD Brushed rebuildable 540 motor, Mtroniks Tio Storm 19 ESC.

- Wiring all correct and double checked
- ESC Set up to LiPo and calibrated correctly according to instructions
- Motor (actually motors as I have two both same issue) work fine if you do a quick test direct on the battery.
- Steering servo works fine
- Throttle servo operates steering servo when connected

When you use the throttle after calibrating the motor buzzes, actually more of a beep, but does nothing. Same fwd and rev. It's like the load automatically drops to zero as soon as ESC connected.

I've tried replacing every single component, including the ESC, which was replaced by MTroniks for a new unit which I thought would resolve the issue, but does not.

Like I say - really tearing my hair out, I just want the darn thing to go forwards and backwards!

All thoughts appreciated and well received.