Originally Posted by
ospower23
Can i used it without the sensor cable?
technically a motor would run without a sensor cable. I'm just not sure how well.
Originally Posted by
tamlok
Picked up a Reventon S but the motor wires are too short. Can I remove and add a new wire at the ESC on the board, I do not want to splice in. I quickly tried heating up the bottom of the wire, but it would not come loose. Any info would be greatly appreciated.
You need a good hot iron and "pre-tin" before applying it.
Originally Posted by
Blui3
Trying to find part number for MMM 9.5T-21.5T Rotor hi-torque
Not sure which one you are looking at, but here's a few.
RS13803NA Competition V3.0 9.5T-21.5T Rotor
RS13802 9.5T-21.5T Rotor - Purple ring
http://www.speedpassion.net/en/catagory.asp?c=mtr&sc=30