Hey guys, does anyone can tell if hobbywing quicrun 10bl60 sensored 60a esc can support using bluebird dmg621 servo without adding external bec??
The esc paired with xerun 17.5t motor
Just wondering..

This is the esc spec
Model: QUICRUN-10BL60-SENSORED

Cont./Peak Current/ Resistance: 60A / 380A / 0.0008 Ohm

Motor Type Supported: Sensored / Sensorless Brushless Motor

Car Applicable: 1/10 & 1/12 On-road / Off-road / F1 / Drift car race / Street race for fun / Club racing / STOCK race with 0 timing / Drift car race

Motor Limit:
For 4-6 cells NiMH/2S Lipo
≥8.5T(1/10 On-road), ≥13.5T(1/10 Off-road) *"T" indicates the limit value of motor turns when the ESC timing is set to 0. The larger the timing, the more turns the motor needs.
8-9 cells NiMH/3S Lipo
≥13.5T(1/10 On-road), ≥17.5T(1/10 Off-road) *"T" indicates the limit value of motor turns when the ESC timing is set to 0. The larger the timing, the more turns the motor needs.

Battery: 4-9 Cells NiMH / 2-3S Lipo
BEC Output / Operating Voltage of the Cooling Fan: 6V@2A, Linear Mode / 6V (The cooling fan gets its power supply from the built-in BEC)

Dimension / Weight: 33mm(L)*28mm(W)*31.5mm(H, with cooling fan) / 59g (with wires, without cooling Fan)