R/C Tech Forums - View Single Post - Tekno RC EB48.3 Thread
View Single Post
Old 08-25-2016 | 08:56 AM
  #2114  
ezlight
Tech Master
 
Joined: Oct 2014
Posts: 1,167
From: Maine
Default

Originally Posted by werner sline
too bad tekno didn't make this shaft a bit shorter to let more room to the chassis flex
that is the weak point of this buggy. but the rest is really tough !
There's probably a good half inch of play front to rear in the front driveshaft. I actually feel it's too much. How much more do you want to allow for bad landings? Not sure I would call that a weak point of the car. Although I did see a picture of a severely bent driveshaft on FB, but couldn't imagine how the heck the guy pulled that off.

I've been running tekno for almost 2 years, and crash rather spectacularly at times, and have yet to bend a driveshaft. I have had my truggy flex enough to have my rear driveshaft pop out though.
ezlight is offline