R/C Tech Forums - View Single Post - Nitro rc car won't move/start
View Single Post
Old 08-22-2016 | 06:00 PM
  #21  
Bundy_Bear's Avatar
Bundy_Bear
Tech Elite
iTrader: (11)
 
Joined: Apr 2004
Posts: 2,882
From: Brisbane, Qld
Default

Originally Posted by Micah222
Ok ok, I got the car to move a little but when I take the igniter out it will immediately shut off. This means I need to turn th low speed needle, but I don't know where that is located. I'm pretty sure of this because the setting is to rich and there's to much fuel which makes sense because it used a full tank in about 5 minutes. Correct me if I'm wrong but what I need to do is locate the low speed needle and turn it in? Or should I do something with the high speed needle? Please let me know I am almost done with this thank you!!

-Micah222
If you still running the motor in I would only touch the HSN (screw 3 on manual) like has been suggested. Apart from that maybe wind in the idle screw a little to get the engine to idle a little higher to keep it running (Screw 4 on manual).

Engine manual
Bundy_Bear is offline