R/C Tech Forums - View Single Post - APS 3-in-1 Dyno Charge
View Single Post
Old 03-20-2005 | 06:14 PM
  #64  
MartynD
Tech Regular
 
Joined: Dec 2004
Posts: 444
From: Oshawa, Ontario
Default

katermdb

I run with Toodeep, he's a little faster down the straight than I am.

Saturday night vs those motors he posted specs for, my P2K2 which pulled 3.7A and 17,800rpm wasn't far behind on the straight. In the infield he was faster but then again so was everyone else (even when I changed motors my laptimes didn't change) newb that I am... I am .5 to 1 sec a lap slower than the experienced guys at our track. My best laps were in the 10.4 range, think Toodeep's were around 9.9 or perhaps 10 flat.

No load really means nothing, the rpm and amp data is not much more than a toy, though it can tell you if you have a serious motor problem.

Try a Reedy Quad mag, you will get the same amperage as your stocks and lower rpm typically. Which is faster? +)
MartynD is offline