Originally Posted by
lyons238
I wouldn't recommend this servo horn. There is a 5mm gap from the output gear to the end of that servo horn. You want the steering link to run perfectly straight from the servo horn to the servo savor/mount point on the steering arm/rack. This 5mm gap would make you have to run a number of spacers between the servo horn and the ball stud as I already have to run spacers even with a much flatter servo horn. Also if you're using a Savox servo or a Hitec servo where the output gear is further forward relative to the servo mounting tabs, than that will further embellish this issue.
Show a pic of your steering link relative to your servo horn and servo savor. does it run perfectly square across or is it angled?
I have had no issue with the arm or the angle. Works great...