Overspeed

I did the wing upgrade on the XXl2-E today. Here are some pictures.








You have to make a cut on the body, which can be a bit challenging because it's so think. I used wire cutters and an exacto knife, chipping a bit away at a time. I then sealed the exposed area with a flame to prevent any chipping or fraying. The cut has a width of 6cm and a depth of 5.5cm. You pull four screws off the rear shock tower and the wing support posts slide right on. You then attach it using the longer screws provided in the kit. Make sure not to over tighten then as the plastic is quite soft. Looking from the top down, you can't tell it's been modded.