R/C Tech Forums - View Single Post - Poorly tinned wires
Thread: Poorly tinned wires
View Single Post
Old 06-14-2016 | 02:30 PM
  #7  
Miko1976
Tech Adept
 
Joined: Oct 2015
Posts: 232
From: New York
Default Poorly tinned wires
Originally Posted by Geezatec
New motor installed? Try recalibrating the ESC, if still cogs Try smaller pinion. Make sure you set your Voltage cutoff correctly.
Not a new motor. Just put new wires in. Changed the sensor wire & the cogging stopped on load but happens sometimes after landing a jump.
Miko1976 is offline  
Reply