View Single Post
Old 03-17-2005, 03:54 PM   #3683
JWATT
Tech Regular
 
Join Date: Nov 2003
Location: Driver's Stand- Tulsa, OK
Posts: 280
Default

Take all hinge pins out (outer & inner) and verify that they are not bent (roll on a flat piece of glass). Re-install pins, remove shocks, and verify that arms will fall freely when lifted up.
Measure shocks to be sure all are of the same length, compare front to fronts and rears to rears. Re-install shocks and be sure they are mounted in the same positions, when comparing the left and right rear and left and right front. Set ride height. Set car on glass again, find center of car, lift car off glass and see if both rear tires lift at the same time. Do the same for the front. If all this proves ok, then put back on tweak station, should be ok there too.
JWATT is offline   Reply With Quote