R/C Tech Forums - View Single Post - Receiver and transmitter won't bind
Thread: Receiver and transmitter won't bind
View Single Post
Old 05-29-2016 | 09:15 AM
  #7  
Riverbluff
Tech Regular
 
Joined: Nov 2013
Posts: 425
From: Tucson, AZ
Default
Originally Posted by Drporter
So I Purchased a TeamAssociated XP2G transmitter/receiver combo. The receiver is a XP TRS403-sst. After finally getting the dang thing to finally bind, I took it out for a test run. Unfortunately I lose signal at about 20 feet. I have to them walk up to the car and don't get a return of signal until I get a few feet from the car. Any ideas on what's going on? I've checked the antenna and it seems completely intact.
Go through your bind sequence again. After you bind it, you need to do the ESC calibration process to calibrate the ESC to the radio. Also, make the battries and good.
Riverbluff is offline  
Reply