Originally Posted by
K_King
S6240 is an in between sized servo.
Which rear hexes are you running - +.75mm or +1.5mm? What is the benefit of one vs. the other?
Do you have to use different rear axles?
Also, after reading (some of) Fred Swain's posts in the camber gain thread, I think I'd like to try a higher roll center. Does anyone use the HRC front pivot block and/or rear HRC pivot block sets? Are they even necessary?
BTW, I will soon install the exotek laydown and I have the +3mm rear hubs to try out as well - if that makes any difference.
Thanks