Originally Posted by
ray_munday
Ive run my SC5M on loose conditions and Ive found it very driveable. I run the Brass D block and with a shorty battery, the weight distribution is similar to my Sc10 but the handling is much more responsive.
The SC5m is much better with grey front springs and going up in front oil. It also needs the ball diff to be run much tighter than in a buggy. If you run it loose, it turns in too hard and diffs out on exit.
Ive adapted a front sway bar to my truck (JConcepts SC10 bar) and use a standard B5M rear bar and this also makes a big difference to stability in high speed sweeping corners.
Here is my setup sheet from 2 weeks ago (note that I was using 4mm trail not 2mm trail - mistake on the sheet).
Ray
http://site.petitrc.com/setup/associ...eilor20160507/
Thanks!
Would you recomment the front sway bar? I think I might tighten the Diff. It SHOULD be way to loose, cause I ran on Carpet the first time. That may be a forgotten issue