Originally Posted by
Mopar2Ya
I set mine on a vise & using a bolt(female)/4way wrench(male) tap them in, the female ends will go in too far if hit too hard.
I ended up making a double sided press tool. The one side slides snug over the male conector and the other slides over the slightly larger female conector. Then using a small hammer with a light tap I pressed each bullet into the plastic connector with the tool!
I used a short piece of aluminum bar stock & machined each side in a lathe to a few thousands over the male bullet on one side of the aluminum bar stock and then a few thousands over the female bullet on the other side. Then I shrink wrapped the tool to insulate it when pressing in a hot connection. It sure made pushing the bullets into the plug easy. Castle should of included something along the lines of this for the multi pack. Lol