View Single Post
Old 05-12-2016, 07:54 AM   #51
Tech Elite
j.d.roost's Avatar
Join Date: Jul 2008
Posts: 3,087
Trader Rating: 28 (100%+)

Originally Posted by sg1 View Post
Did you lower the upper a-arms as well?
I put 2mm shorter lower standoffs in and then lowered the upper A-Arms 4mm and lowered the bell crank 2mm.
It changed the roll center and increased corner speed on the new CRC carpet.
How did you lower the upper arms?
Did you mill the servo holder?

Also wanted to add I only switched from the stock front spring because I lost one. The tamiya gold seemed closest to the same rate.
Roche usa
R.I.P. Jon Williams

Last edited by j.d.roost; 05-12-2016 at 08:19 AM.
j.d.roost is offline   Reply With Quote