Last Sunday the build was that far to test it on fresh engine. Sadly the electric motor was to weak and the adapter shaft was to small to make a tight clamp.
Today arrived a new 550 size transmission motorwith 7x the force of the old one. Also did a quick work on the lathe for a new adapter shaft.
I still had one fresh motor which is now rotating in the bench. The new electric motor can handle the pinch and the lower heating power of about 80 watt can still heat the whole bath up to my starting temperature of 95 degrees.
A small movie:
The one thing I have to do is add some screws to mount the controlpanel, 4 bolts for the cap ant tighten some screws.