I was wondering if my servo (2yrs old) is still good enough for the EB48.3 at race level.
I currently have a Hitec 7954sh set with 7.2v (through the xr8+ HW).
It produces a torque of about 400oz.inch and a speed of 0.12s.
Should I keep it until it dies or would I benefit from upgrading ?
I was looking at servos around 0.09s for a 250-300oz.inch thinking of the savox 1267sg
Or even should I go banana and get the 2284sg at 0.65s for the same torque ? I like the aluminium case as the Hitec's is getting pretty beaten up where you screw it to the chassis... (direct mount though as I lost the rubber pads a long time ago).
thanks