Originally Posted by
antlockyer
I also moved the ESC over to the right hand side to offset some of the motor weight. I really want to shorten some of the wires, its a terrible mess.
Are you referring to the motor/battery wires or the servo/ESC wire?
This is my M-Rage, but I cut the motor wires shorter and soldered it. Also for the servo/ESC wires I coil wrapped it around my screw driver shaft to shorten the overall length. If you are certain you won't be moving the electronics to another car, you can buy pins, connectors, and crimper to shorten the servo/ESC wires for a nice clean finish.
http://www.rctech.net/forum/members/...bsr-m-rage.jpg
Originally Posted by
antlockyer
M05 how much servo travel do you guys have dialed in i.e. the percentage on your transmitter. I feel like I have to take a whole bunch out of mine to stop it overpowering the steering setup if that makes sense? Looks like it goes way too far.
It depends on my tire and suspension setup and course, but I do remember dialing out steering using dual rate on my M05.
