Originally Posted by
AZJP
Front 1.4x3 32.5 grey flat arms standard links, +1mm inside.
Rear 1.6 30 blue rear motor rams -2 inside +2 on hub
But like I said I've been changing roll centers to find something that works, but the above setup is what I generally have been running.
Mod setup vs stock setup is not even close from what I've found
Look below.
I know on the rear I ran the schelle camber block and ran the 2nd inner hole, no washers on it. You had to stiffen the car up a TON to get it to not traction roll and be too touchy.
What toe and anti squat? I would run 3x1, and then negative 5 on the rear hubs.