No reversed wires. I drove the car earlier yesterday and it was perfect, the wiring configuration was the same. Then after coming inside for a couple hours, I was going to go drive it again. When I turned it on, this problem occurs.

I did unsolder, and resolver. With no luck. Orientation is correct on the wires.

I only removed the bottom part of the can, to remove the rotor. No washers were removed .

With the wiring correct, I'm worried that my RX8 Gen 2 has lost a phase. Or worse. The RX8 Gen2 seems to work fine though. But it is under warranty. It's only 2 or 3 weeks old now.