Originally posted by InitialD
I don't think there are any instructions... Just look at the pics at mytsn.
A small note. Make sure when you install it, it's centered left and right. Makes sure the end of the sway bar linkage does not touch the rear upper arms on suspension compression when you set the sway bar to connect the outer hole of the lower rear arm. If I'm not mistaken, you need to set it about 2 to 3 mm from the end of the bar to "clear" the upper rear arm.
Perhaps you should try stock setup with the thin 2 mm sway bar first to see how it suits your track. Then change to the thicker rear sway bar (either 2.5 or 3 mm).
Thanx for the link. It helped out alot
. I think i will use the new swaybar. Some guys at the track I run at says it works better.
Thanx again