Originally Posted by
ic-racer
Dealing with 'camber slop' when translating values from the software model to the physical car. Seems like most of my cars have 0.5 to 1.0 degree of slop which is not evident at rest or on setup blocks unless one pushes the setup blocks out slightly at the top.
For example if I set 0.5 camber on the wheels at rest, once the car starts cornering that 0.5 becomes zero before any force can be transmitted through the tire.
Wondering how others deal with this or if everyone els's car has no slop.
Everyone I know sets the car up at .5mm higher than desired camber when using a setup station.