View Single Post
Old 03-07-2016, 02:37 PM   #490
Tech Master
YoDog's Avatar
Join Date: Aug 2006
Location: Lompoc, Ca.
Posts: 1,706
Trader Rating: 26 (100%+)

Originally Posted by BullFrog View Post
It's very simple just get some 1 1/2mm spacers from anyone. You will need 8 total. You'll probable need some longer 4/40 screw. I got them elsewhere. In the front you put the spacers under the front end mounting plate (4). Do the same for the rear pod plate- you'll need longer screws again. I hope that helps.
Since this is a CRC car, couldn't he just use the plastic front end risers that come with the kit for the front?
That's what I did. I just used the 3mm riser and added 2mm shims in the back with the high axle inserts.
R-Factor RC Products
AE- TC6.1WC, TC6.2, RSD6, B5M
CRC- GenX10 WGT & Pro10 Prototype, WTF1, Xti 1/12
R-Factor RC- TC4-R, P8 PanCar
Not as Fast as I want to be but too old to Whine about it... 8-)
YoDog is offline   Reply With Quote