Originally Posted by
Cain
richmtb01: what did you find for the solution to the issue and what servo are you using exactly? I am looking to use this:
Futaba S9372SV servo
http://www3.towerhobbies.com/cgi-bin...&I=LXFSGA&P=ML
Dimensions:
in your and anyone elses opinion, will this be a problem? and if so, what solution options are there short of a different servo?
Great minds think alike! That's the same servo I'm using and it's getting caught on the lower protion where it turns from the plastic bottom cap to the aluminum case. Everything worked great till I bolted it to the chassis. I unscrewed the four servo bolts to slam it as close to the chassis and it's still getting caught. I will probably remove the Ackerman and shave it down a bit. I don't see how you can add a spacer anywhere.....but I also haven't spent a ton of time trouble shooting it yet