Originally Posted by
rekim
Which screws need tighten for pulling. I have it too. Not bad but a bit
Just take a nice MIP driver and check every single screw that goes into hard plastic. Front, back, top, and bottom. I noticed my motor was lifting a little bit when I held my car and gave it throttle. Tightened everything and that was gone, and ended up with a better driving car. I wouldn't be surprised if many people have this issue and don't realize that with the hard plastics, you need to check and make sure they are actually fully seated. Don't get all ham fisted and strip stuff out, but it's definitely a different feel from, say, TLR plastics which are extremely high quality but not at "hard" as the X-ray hard stuff is.