View Single Post
Old 02-21-2016, 11:41 PM
  #486  
Dan
Tech Elite
iTrader: (53)
 
Dan's Avatar
 
Join Date: Oct 2001
Posts: 4,682
Trader Rating: 53 (100%+)
Default

Almost done building the new FC16. Anyone have issues with the side dampers pushing the pod down on the left side?

I have disconnected the side dampers so I have isolated the issue. I'm thinking about shortening the ball connector that goes on the aluminum end of the damper cylinder...

Nvm: found out the angle was limited on the ball connector. Raised up the ball ends so the tubes are less of an extreme angle, seems to have fixed it.

Last edited by Dan; 02-22-2016 at 11:01 PM.
Dan is offline  
Reply With Quote