Originally Posted by
Malazan
I'm having an issue with my servo horn and linkage.
I have the single hole 25T Tekno Horn, if I gap my servo linkage to 1mm like instructions say, I cannot get the linkage to be parallel like the manual says to? Page 22 of the manual. I end up having to gap it like 3mm, is this ok?
Also I had to remove the 2 washers above the ball end so my wheels would clear, do I need to remove any other washers to compensate for this?
Also, how are you guys running your antennas, I notice a lot of short tubes, where can I find one? The one that comes in the kit sucks.
I've also read were some people just wrap them and keep them inside the receiver box?
Thank you
I run antennaless receivers so I don't use them but what do you mean about "The one that comes is the kit sucks" ? Cause its long? Just cut it to the length you need. And yes you can wrap most of them and still be ok for most situations if you decide to go that route.